1965-69 Ford/Mercury Water Temperature Sender V8 Engine For Gauge

1965-69 Ford/Mercury; Water Temperature Sender; V8 Engine; For Gauge

Replacement water temperature sending unit with 3/8″- 18 NPT thread. This brass sensor screws into intake manifold to activate the temperature gauge in the dash. This is an accurate reproduction of the original part for various 1967-69 Ford and Mercury models with V8 engine and temperature gauge in the dash. However, you can use this temperature sending unit on a wide variety of 1965-69 Mustang models with gauges as a service part.

Note: Replaces Ford Part #: C6DZ-10884-B (SW-552) or C9WY-10884-A (SW-888). Designed for 1965 models that were built after Sept. 1st 1965. The 1969 351 Windsor temperature sending unit is obsolete. This temperature sending unit is recommended as the closest replacement.

Specifications:

• Temp Sender Switch Temp Rating : 15.2-19 Ohms Resistance At 220 Deg F
• Temperature Switch Thread Size : 3/8″ x 18 NPT

Engine Applications:

• 6 cylinder
• 8 cylinder 289, 302, 351W, 390, 427, 428

Ford Applications:

• 1966-1967 Ford Falcon (6 cylinder)
• 1966-1967 Ford Falcon (8 cylinder
• 1966-1968 Ford Fairlane (6 cylinder)
• 1965-1968 Ford Galaxie/Passenger Car (8 cylinder
• 1966-1968 Ford Rancher (6 cylinder)
• 1966-1969 Ford Ranchero (8 cylinder
• 1966-1969 Ford Mustang (6 cylinder)
• 1969-1969 Ford Mustang (390ci, 428ci
• 1965-1969 Ford F-Series truck (stamped 260, 3/8″-18)
• 1966-1969 Ford Bronco
• 1966-1967 Ford Econoline (from serial # 751,001)

Mercury Applications:

• 1966-1967 Mercury Comet (6 cylinder)
• 1966-1967 Mercury Comet (8 cylinder)
• 1970-1970 Mercury Comet Spoiler (351ci)
• 1967-1969 Mercury Cougar (8 cylinder)